Rest (music)

One-bar rest

When an entire bar is devoid of notes, a whole (semibreve) rest placed at the middle of the measure is used, regardless of the actual time signature. Historically exceptions were made for a ⁴
₂ time signature (four half notes per bar), when a double whole (breve) rest was typically used for a bar's rest, ³
₂ or ⁶
₄ time, where a dotted whole rest was used, and for time signatures shorter than ³
₁₆, when a rest of the actual measure length would be used. Some published (usually earlier) music places the numeral "1" above the rest to confirm the extent of the rest.

Therefore, dotted whole rests and dotted rests of longer values are very rarely seen.

Occasionally in manuscripts and facsimiles of them, bars of rest are sometimes left completely empty and unmarked, possibly even without the staves.

Multiple measure rests

Seven measure multirest, notated variously

In instrumental parts, rests of more than one bar in the same meter and key may be indicated with a multimeasure rest (British English: multiple bar rest), showing the number of bars of rest, as shown. A multimeasure rest is usually drawn in one of two ways:

• As a thick horizontal line placed on the middle line of the staff, with serifs at both ends (see above middle picture), or as thick diagonal lines placed between the second and fourth lines of the staff, resembling a large heavy minus sign or equals sign set at a slant (the diagonal style is much less common than the horizontal one; although a small number of publishers use it, it is more commonly found in modern manuscripts in a casual style). Both variants of thick line rests are drawn in the same shape each time, regardless of how many bars' rest they represent.
• The older system of notating multirests (deriving from Baroque notation conventions that were adapted from the old mensural rest system dating from Medieval times) draws each multimeasure rest according to the picture above right unless it will exceed a certain number of bars; rests longer than that limit are drawn using the thick horizontal line mentioned above. How long a multimeasure rest must be before resorting to a horizontal line is a matter of personal taste or editorial policy; most publishers use ten bars as the changing point, however, larger and smaller changing points are used, especially in earlier music.

The number of bars for which a horizontal line multimeasure rest lasts is indicated by a number printed above the musical staff (usually at the same size as the numerals in a time signature). If a change of meter or key occurs during a multimeasure rest, that rest must be divided into shorter sections for clarity, with the changes of key and/or meter indicated between the rests. Multimeasure rests must also be divided at double barlines, which demarcate musical phrases or sections, and at rehearsal letters.

Dotted rest

A rest may also have a dot after it, increasing its duration by half, but this is less commonly used than with notes, except occasionally in modern music notated in compound meters such as ⁶
₈ or ¹²
₈. In these meters the long-standing convention has been to indicate one beat of rest as a quarter rest followed by an eighth rest (equivalent to three eighths). See: Anacrusis.

General pause

In a score for an ensemble piece, "G.P." (general pause) indicates silence for one bar or more for the entire ensemble. Specifically marking general pauses each time they occur (rather than writing them as ordinary rests) is relevant for performers, as making any kind of noise should be avoided there—for instance, page turns in sheet music are not made during general pauses, as the sound of turning the page becomes noticeable when no one is playing.