UO2(H2O)2+[CH3CO−2]2 Hydrated crystal structure | |
| Names | |
|---|---|
| IUPAC name
Uranium bis((acetato)-O)dioxo-dihydrate | |
| Other names
Uranyl ethanoate; Uranyl acetate dihydrate | |
| Identifiers | |
3D model (JSmol) |
|
| ChemSpider | |
| ECHA InfoCard | 100.007.971 |
| EC Number |
|
PubChem CID |
|
| UNII |
|
CompTox Dashboard (EPA) |
|
| |
| |
| Properties | |
| UO2(CH3COO)2 (anhydrous) UO2(CH3COO)2·2H2O (dihydrate) | |
| Molar mass | 424.146 g/mol (dihydrate) |
| Appearance | yellow-green crystals (dihydrate) |
| Density | 2.89 g/cm3 (dihydrate) |
| Melting point | decomposes at 80 °C (dihydrate) |
| 7-8 g/100 ml | |
| Solubility | slightly soluble in ethanol |
| Hazards | |
| GHS labelling: | |
| Danger | |
| H300, H330, H373, H411 | |
| P260, P264, P270, P271, P273, P284, P301+P310, P304+P340, P310, P314, P320, P321, P330, P391, P403+P233, P405, P501 | |
| Safety data sheet (SDS) | External MSDS |
Except where otherwise noted, data are given for materials in their standard state (at 25 °C [77 °F], 100 kPa).
| |
Uranyl acetate is the acetate salt of uranium oxide, a toxic yellow-green powder useful in certain laboratory tests. Structurally, it is a coordination polymer with formula UO2(CH3CO2)2(H2O)·H2O.

In the polymer, uranyl (UO22+) centers are bridged by acetate ligands. The remainder of each (heptacoordinate) coordination sphere is provided by an aquo ligand and a bidentate acetate ligand. One water of crystallization occupies the lattice.
Uranyl carboxylates are known for diverse carboxylic acids (formate, butyrate, acrylate).
Uranyl acetate is extensively used as a negative stain in electron microscopy. Most procedures in electron microscopy for biology require the use of uranyl acetate. Negative staining protocols typically treat the sample with 1% to 5% aqueous solution. Uranyl acetate staining is simple and quick to perform and one can examine the sample within a few minutes after staining. Some biological samples are not amenable to uranyl acetate staining and, in these cases, alternative staining techniques and or low-voltage electron microscopy technique may be more suitable.[citation needed]
1% and 2% uranyl acetate solutions are used as an indicator, and a titrant in stronger concentrations in analytical chemistry, as it forms an insoluble salt with sodium (the vast majority of sodium salts are water-soluble). Uranyl acetate solutions show evidence of being sensitive to light, especially UV, and will precipitate if exposed.[citation needed]
Uranyl acetate is also used in a standard test—American Association of State Highway and Transportation Officials (AASHTO) Designation T 299—for alkali-silica reactivity in aggregates (crushed stone or gravel) being considered for use in cement concrete.[citation needed]
Uranyl acetate dihydrate has been used as a starting reagent in experimental inorganic chemistry.
The compound can be prepared by treating uranium trioxide with acetic acid:
The acetate ligands of uranyl acetate can be replaced to give a variety of uranyl complexes. Uranyl acetate can also be reduced by zinc to give the uranium(IV) acetate (U(OAc)4).
In general, uranium salts exhibit nephrotoxicity. Normal commercial stocks from depleted uranium have typical specific activity 0.37–0.51 microcuries per gram (14–19 kBq/g), too weak to harm from outside the body. However, uranyl acetate is very toxic if ingested, inhaled as dust, or absorbed through cut or abraded skin.[citation needed]
Microbiologists have developed a number of alternative stains: neodymium acetate, platinum blue, hafnium chloride, and oolong tea extracts.
{{cite book}}: ISBN / Date incompatibility (help)